: Engineered for advanced thermal applications spanning 50°C to 235°C. Unboxing and Laboratory Benchtop Setup
Quick Access to the Manual Link You can download the full, official AMETEK Brookfield CAP 2000+ Viscometer Operations Manual directly from the manufacturer's server. This document (Manual No. M02-313) provides comprehensive guidance for the installation, programming, calibration, and maintenance of the CAP 2000+ series cone and plate viscometers. Introduction to the CAP 2000+ Viscometer The AMETEK Brookfield CAP 2000+ Go to product viewer dialog for this item.
Before calling technical support, the manual’s "Troubleshooting" chapter can help you resolve:
The CAP 2000 is available in several configurations: cap 2000 viscometer manual link
: This specific manual is intended for instruments with a serial number beginning with "CPN" . If your unit has a "CP" prefix, you must contact Brookfield directly for a legacy manual. Safety and Maintenance BROOKFIELD CAP 2000+
(standardized by the Imperial Chemical Industries), ensuring that every bucket of paint from London to Los Angeles had the exact same flow properties. Its reputation for being "rugged" made it a rare piece of precision lab equipment that could actually survive the messy, high-temperature reality of a factory floor. Key Features at a Glance: CAP2000 Viscometer - AMETEK Brookfield
Sources: Product brochures and official specifications If your unit has a "CP" prefix, you
Operating the viscometer requires strict attention to thermal balancing and mechanical alignment to avoid damaging the tungsten carbide plate assemblies: BROOKFIELD CAP 2000+
: 0.2 Poise to 15,000 Poise (dependent on the specific cone spindle and speed selected).
The primary manual for the Brookfield CAP 2000+ Viscometer is available directly from the manufacturer. Official Manual & Quick Start Full Operations Manual Brookfield CAP 2000+ Operations Manual (PDF) 5–75 °C) model
For the (low‑temperature range, 5–75 °C) model, ManualsLib hosts a complete 37‑page manual that includes the same core operating instructions and appendices:
Upon startup, the CAP 2000+ will prompt for speed setting (RPM), with default settings often set at 750 (50Hz) or 900 (60Hz). II. Operating Procedures
The instrument remembers the last cone number entered when it was powered off. If you swap cones with the same number, you must perform a cone calibration procedure (Section III.4 of the manual). Otherwise, the display will show flashing “0s” to indicate that the cone is not calibrated.