To Epon Verified | Firmware Huawei Hg8245h Gpon

The "OMCI Status" or "GPON Mode" labels should change to or OAM Status .

Log in with the engineering credentials (commonly root / admin , telecomadmin / admintelecom , or root / adminHW ). To check the current optical mode, input: get optical mode To force the switch to EPON, input: set optical mode epon firmware huawei hg8245h gpon to epon verified

Uses standard Ethernet packets and operates symmetrically at 1.25 Gbps both upstream and downstream. The "OMCI Status" or "GPON Mode" labels should

: Registered, sync OK, but no VLAN auto-sense — manual config needed. : Registered, sync OK, but no VLAN auto-sense

Connect your PC directly to a LAN port on the router. Open a browser and enter the default IP address: 192.168.100.1 2. Locate Firmware Management

Once the verified firmware is active, you must instruct the bootloader to switch the optical mode from GPON to EPON.

Wait 5 to 10 minutes until the device reboots entirely. Method B: Flashing via OntConfig Utility / TFTP (Advanced)