Galaxy Aqua Premier Installation Manual Better

Tubing was not cut squarely or inserted deeply enough.

Turn on the water supply and let it flow through the showerhead for 60 seconds.

Verify that both your property's primary main valve and secondary line valves are turned to the wide-open position. Clean out the internal debris basket. galaxy aqua premier installation manual better

Before connecting the pipe to the heater, Alex ran water through the pipe to flush out any debris that might clog the system.

To maintain optimal performance and validate your warranty, ensure your installation location meets the following technical parameters: Operational Requirement 40 PSI minimum – 80 PSI maximum Water Temperature 40°F (4°C) minimum – 100°F (38°C) maximum Power Supply 110V/220V AC (Only required for UV/Booster pump models) Location Indoor use only, protected from freezing temperatures Feed Water Source Potable municipal cold water line only Tubing was not cut squarely or inserted deeply enough

Connect the T-valve water source to the Inlet port of the external pre-filter.

Ensure the unit is properly earthed according to current IEE regulations. 5. Fitting the Cover and Accessories Clean out the internal debris basket

The automated self-flushing mechanism built into the Galaxy Aqua Premier runs periodically when the machine is idle. Leaving the unit powered on prevents premature membrane fouling. Troubleshooting Common Installation Issues Potential Cause Water leaking from quick-connects Tubing cut at an angle or not pushed in deep enough.

If mounting on tiles, mount the unit on top of the tiles, never tile up to the unit.