Gunnebo Speedstile | Fl Installation Manual
Connect the building’s fire relay to the dedicated emergency input. This circuit must be wired as Normally Closed (NC) so that an open circuit or loss of power automatically releases the glass wings for free egress. 5. Mounting the Glass Wings
Place the cabinets over the pre-installed floor conduits. Ensure that the master and slave infrared sensor windows face each other exactly.
Use a torque wrench to tighten the wing retention bolts progressively to the specified torque limit to prevent cracking the glass inserts. 6. Commissioning and Testing gunnebo speedstile fl installation manual
is a high-end, fast-acting speed gate designed for secure, authorized access control in areas with high pedestrian traffic. Proper installation is critical to ensure the longevity, security, and smooth operation of these automated entrance systems.
Anchor bolt kits (typically M10 or M12 mechanical expansion anchors) Connect the building’s fire relay to the dedicated
Place the cabinets into position based on the layout plan.
Position the cabinets over the holes, carefully feeding pre-laid cables through the chassis base cutouts. Mounting the Glass Wings Place the cabinets over
The Gunnebo SpeedStile F and SpeedStile L are popular high-performance optical turnstiles used to control pedestrian access in lobbies, secure areas, and transport hubs. This guide walks facility managers, installers, and integrators through a complete, practical installation process: planning, tools and materials, mechanical installation, electrical and control wiring, safety and sensor alignment, configuration, testing, troubleshooting, and maintenance. Use this post as a structured complement to the official manufacturer documentation and on-site requirements; always follow local electrical codes and the official Gunnebo installation manual where it differs.
Torque the anchor bolts to the manufacturer’s exact specification (typically Step 3: Installing the Glass Barriers Ensure the drive shaft is in the fully closed position.
Verify battery backup capacity; check electrical terminal torque; update firmware. Common Troubleshooting Codes