Manual Alpina It 31015 ((full)) Link
To prevent the extension cord from unplugging during use, utilize the built-in cable strain relief hook located on the rear handle:
Test for a spark by grounding the plug threaded base against the engine block while pulling the starter rope.
The refers to the comprehensive operational, safety, and maintenance guide for the vintage Alpina petrol chainsaw line, often associated with part number/MPN 3210620 and classic models like the P34, 330, 380, 432, and 438.
The exact you are experiencing (e.g., no spark, bogs down under load, chain won't spin) Manual Alpina It 31015
| Problem | Likely Cause (per manual) | Solution | |--------|----------------------------|----------| | Engine won’t start | Old fuel, wrong fuel mix, or clogged carburetor | Drain fuel, mix fresh 2-stroke oil (40:1 or 50:1). Clean carburetor jets. | | Engine starts but dies when throttling | Dirty air filter or restricted fuel line | Replace air filter. Check fuel line for kinks. | | Cutting head spins at idle | Idle speed too high or clutch springs worn | Turn idle screw counterclockwise. Replace clutch springs if needed. | | Excessive vibration | Loose cutting blade or damaged drive shaft | Tighten blade nut to spec (check manual torque value). Inspect shaft for damage. | | Line won’t feed | Line melted inside head or worn feed mechanism | Disassemble head, clean, replace line (2.4 mm recommended). |
The infeed and outfeed tables must be perfectly co-planar with the base plate. The manual provides a crucial tip: “Tighten the bolts gradually, alternating between front and rear, to prevent table warping.” Use a precision straight edge to verify that there is no daylight between the table and the main base.
Электропила alpina energy it 31015 какая цепь To prevent the extension cord from unplugging during
If you are looking for related to Alpina brands, you should visit their official support pages:
The Alpina IT 31015 is capable of calibration down to 0.1 mm. The manual provides three essential adjustment procedures:
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Clean carburetor jets
I can provide the exact step-by-step diagnostic or part numbers you need! Share public link
A perfectly tensioned chain should still move freely around the bar by hand (always wear heavy gloves while checking this). Securely torque down the guide bar retaining nuts. ⛽ Fueling, Lubrication, and Fluids
Because this is an older two-stroke engine, running straight gasoline will destroy the cylinder piston immediately. You must mix unleaded gasoline with high-quality 2-cycle air-cooled engine oil. For legacy Alpina engines, a ratio of 40:1 or 50:1 (depending on the specific oil formulation) must be used. Always mix the fuel inside an approved clean container before pouring it into the chainsaw tank.
