Merlin Gerin Multi 9 Ic 2000 P Manual < iOS >

Fluorescent Lamps (Corrected/Uncorrected): High capacity compliance (refer to specific ballast load matrices).

The wiring is straightforward, but must follow the diagram stamped on the side of the device:

Let’s begin by demystifying the product itself.

Install the sensor where it receives daylight but not the artificial light controlled by the switch. Merlin Gerin Multi 9 Ic 2000 P Manual

Clean the external sensor cover. Lower the Lux setting. Ensure the front-facing manual override switch is set to "Auto" mode rather than "Permanent ON".

| Specification | Details | | :--- | :--- | | | 230V AC +10% / -15% at 50/60Hz | | Light Level Adjustment | 2 - 2000 lux (Two Ranges: 2-35 and 35-2000) | | Time Delay | 80 seconds (immume to variations shorter than 80s) | | Programmable Cycles | 42 On/Off operations per week (Daily or Weekly) | | Max Switching Current | 10A (inductive load) / 16A (resistive load) | | Max Switching Power (Incand.) | 2600W | | Max Switching Power (Fluor.) | 2300VA | | Standby Consumption | < 0.5W | | Ambient Temp (Operation) | -40°C to 70°C | | Protection (Unit / Sensor) | IP20 (main unit) / IP66 (sensor front) | | Mounting | TH35 DIN rail (EN 60715) |

Forces the output relay to remain open indefinitely, ignoring both time slots and low light measurements. Troubleshooting Guide Probable Cause Corrective Action Connected lights do not turn on at dusk. Incorrect Lux threshold adjustment or wiring fault. Clean the external sensor cover

It combines the features of a standard light-sensitive switch with a single-channel programmable time switch .

Manual Merlin Gerin IC2000P (page 1 of 2) (English) - Libble.eu

Connect the two wires coming from the outdoor photoelectric cell to Terminals 3 and 4. Note: The sensor circuit operates on low voltage; never connect mains power to terminals 3 and 4. | Specification | Details | | :--- |

Snap the IC 2000 P onto a standard DIN rail inside your electrical distribution board. Ensure the environment is dry and ventilated.

Sensor is catching reflected light from the lamps it controls.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

If the connected lighting load exceeds 16A without a supplementary power contactor, the internal relay contacts may have fused together.

Whether you are an electrician installing a new unit or a maintenance engineer adjusting a time schedule, understanding the is crucial for proper operation. This article provides a comprehensive overview of the unit, including installation, programming, and troubleshooting based on the official guidelines. 1. Introduction to the Multi 9 IC 2000 P