Tighten the locking screw or slide the safety pin through the alignment holes to prevent the head from spinning freely or detaching.
The Wella Climazon Millennium is shipped in two primary configurations: the mobile pedestal model or the space-saving wall-mount model. Follow the appropriate section below for your unit. Configuration A: Pedestal (Mobile) Model
The primary processing ring with infrared sensors.
tripod base and tube. The appliance head is secured to the tripod using a specific cable holder/locking mechanism. Wall/Ceiling Mount: Acrobat 2004 system (e.g., WA04/75 or WA04/95 wall arms). Wall Mount (WL04): A wall bearing is fixed to a structural wall. Ceiling/Floor Mounts: wella climazon millenium manual install
Lift the main Climazon head assembly carefully. Insert the heavy pin at the bottom of the head into the top opening of the stand pole.
Determine the ideal mounting height. The pivot point of the wall bracket should typically sit between 1.8 to 2.0 meters (approx. 6 feet) from the finished floor level.
To guide technicians or salon owners through a of the Wella Climazon Millenium hood dryer when the original wall/ceiling bracket is missing, damaged, or when using a third-party stand. Tighten the locking screw or slide the safety
Which are you installing? (Wall-mounted, pedestal, or ceiling?) Are you encountering any error codes on the screen?
This phase transforms components into a functional unit.
Since Wella has discontinued support, try: Wall/Ceiling Mount: Acrobat 2004 system (e
Use the provided heavy-duty bolts to secure the pillar to the base, ensuring it is perfectly upright and tight to prevent wobbling. Step 2: Attaching the Support Arm
: The unit includes integrated infrared sensors that automatically direct heat away from the client's ears, face, and nape for comfort.
| Symptom | Likely Cause | Wella Fix | | :--- | :--- | :--- | | Unit trips RCD immediately | Earth leakage or wet heating element | Dry element with low heat for 30 mins; if persists, replace element. | | No heat, fan works | Thermal cutoff tripped or selector switch failed | Reset thermal button (red button on motor housing). | | Fan runs slow | Blocked filter or incorrect voltage | Clean filter; verify voltage at terminal block. | | Hood rotates on bracket | Bracket locking screw loose | Tighten the hidden Allen screw on the bottom of the wall arm. |