Zclever Security Camera Manual New Guide

: Connect your DVR/NVR to a monitor via HDMI or VGA and to your router using a LAN (Ethernet) cable. Default Login : If prompted for a password during the first login: 6036huanyuan or leave it blank. Resetting Password : If you are locked out: Pinhole Method

Locate the physical reset button next to the SD card slot or on the tail cable.

With the power turned on, press and hold the button down firmly for .

Name your camera (e.g., "Front Door") to complete the setup. 🛠️ Mounting and Physical Installation zclever security camera manual new

: Remove the structural screws from the sides and back panel of the recorder casing.

This guide covers the procedure, app installation, and common troubleshooting tips to ensure your home or business remains secure. 1. Unboxing and Component Overview

Use the mounting template or bracket to mark screw holes on your wall. Drill pilot holes, insert the plastic wall anchors, and securely fasten the bracket using the provided hardware screws. Attach the camera housing and tighten the security joints. 5. Configuring Advanced Features : Connect your DVR/NVR to a monitor via

If your Zclever kit does not include a pre-installed surveillance hard drive, you must manually mount one inside the console to store footage locally.

Avoid pointing the lens directly at bright lights or reflective surfaces like glass windows.

Warning: Do not share your login password. Use the share function exclusively to limit control. With the power turned on, press and hold

A prompt for should appear; select "OK" to enter the system.

If you experience connectivity or performance issues, utilize these standard troubleshooting procedures. Camera is Offline

If pairing fails, press the reset pin for 5 seconds until you hear "Reset successful. Ready for pairing." Then try again.