Dtape Dt50 User Manual Pdf Install Verified -

Briefly press the reference key to choose whether the measurement starts from the top or the bottom (default) of the device.

: Quickly press the unit button to switch the reference point between the front and rear of the device. The rear reference (including the device's own length) is the default.

Measure the hypotenuse (the highest point of the object at an angle).

Leo smiled. He printed the manual and tucked it inside the DT50’s carrying case. Then he wrote on the box in permanent marker: dtape dt50 user manual pdf install

If you notice slight inaccuracies, you can manually calibrate the DT50: Turn the device off.

Point the laser at the target, press READ/ON .

You can easily add or subtract distances without needing a calculator. For example, to get the total length of a room with an alcove, measure the main room, press the "+" button, measure the alcove, and press "MEAS". The DT50 will display the sum. The same process works for subtraction with the "-" button. Briefly press the reference key to choose whether

Press and hold the Clear/Off button for 3 seconds.

: Long-press the Unit button to cycle through meters (m), feet (ft), inches (in), and feet+inches (' ").

, which is often more reliable than a sagging physical tape measure over long distances. Area & Volume Measure the hypotenuse (the highest point of the

: Ensure the package includes the DT50 meter, two 1.5V AAA batteries, a carrying pouch, a wrist strap, and the manual.

A bright laser dot on a reflective surface works best. If the surface is dark or too bright (sunlight), the laser may not return a signal. Error Codes: